NX LinkConnect — Support
Connecting, in three steps
- On the camera: open the wireless menu, choose Link, then Select Files from Smartphone.
- On the iPhone: Settings › Wi-Fi, join the network whose name starts with
AP_SSC_NX. It has no password. - Open NX LinkConnect. It finds the camera and connects on its own.
That network has no internet, by design. iOS will say so, and may offer to switch you back to a network that does — stay on the camera's one until the transfer has finished.
The camera does not appear
- Check the phone is on the camera's network. iOS switches away from a network with no internet more eagerly than you would expect, especially after a lock.
- The camera gives up waiting. It switches its Wi-Fi off if nothing connects within a minute or two. Start the mode on the camera again and reopen the app promptly.
- Allow the Local Network prompt. If it was declined, the app cannot reach the camera at all: Settings › NX LinkConnect › Local Network.
- Use the right mode. Remote Viewfinder connects, but the camera will not share its card in that mode. For transfers it has to be Select Files from Smartphone.
Photos are missing from the grid
These cameras never offer RAW files over Wi-Fi. Only JPEGs are indexed, and only indexed files can be listed — so a camera set to RAW only looks like a camera with an empty card. Set it to JPEG or RAW+JPEG, and the photos you have already taken as RAW will still need the card reader. This is firmware behaviour, confirmed by reading the index on the card itself; no app can work around it.
A transfer is slow
A 20-megapixel original is around 8 MB and the camera's radio sets the pace: expect a few seconds each. The camera also serves one request at a time, so the app queues deliberately rather than asking for several at once — which is what makes the firmware drop the connection. Leave the screen on while a batch runs.
Shooting from the phone says the shot failed
The camera is focus-priority: if autofocus cannot lock, it refuses the shot and reports it. Point at something with more contrast, or switch the lens to manual focus and focus it yourself. Remote zoom needs a power-zoom lens — the 16–50 PZ responds, the manual-zoom lenses have no motor to drive.
Report a problem
Write to jonyk@rxova.dev. Expect a reply within a few days; this is a free app maintained by one person.
For a connection problem, the app's Troubleshooting screen (the ⋯ menu) produces exactly the detail needed — the addresses it tried and what answered. Paste it into the issue.
Another NX camera
Nothing in the app is written for a particular model: it reads what the camera declares and adapts. The NX300 and NX3000 are the two it has been tested against, and reports from other bodies are genuinely useful — the troubleshooting screen's output is the place to start.